Low Cost and 100% Environmentally Friendly

Concentrated formula to remove residues caused by fresh water, TRAC Descaler™ is a safe, non-toxic, and biodegradable fresh water scale remover.

Designed specifically for fresh and brackish water applications, TRAC Descaler™ can safely be used within engines, cooling towers, boilers, or just about any other systems re-circulating water. TRAC Descaler™ will not harm gaskets, seals, plastics or any metals commonly found in water systems.

Unlike our competitors, Trac does not use any harsh acids, instead we use a mild Phosphoric Acid blend. TRAC has developed a truly innovative formula by actually changing the acid’s properties, thus turning it into the safest and most effective descaler on the market! This mild solution penetrates hard to reach areas and removes years of scale build-up, restoring your system to its original condition without damaging piping, seals, and gaskets.

Although mechanical methods of cleaning are available, they often require extended periods of downtime and it is nearly impossible to reach all areas of the system. Chemical cleaning is the only proven method to clean the entire system, thus returning the equipment to its original efficiency.

Areas of Usage
  • Engine Fresh Water Cooling Systems
  • Distillation Towers
  • Heat Exchangers
  • Heat Exchangers
  • Cooling Towers
  • Evaporators
  • Condensers
  • Compressors
  • Radiators
  • Chillers
  • Pumps
  • Boilers
  • Parts
Benefits

Cost Effective: Guaranteed to be ¼ of the price of traditional mechanical methods while yielding superior results.

Fast: while other chemicals are available on the market, most require extensive treatment time. TRAC Descaler® completes most applications within 5 hours!

TRAC Descaler™ completes most applications within 5 hours!

Direction For Uses
  • Isolate the heat exchanger from the rest of the system and disconnect the water inlet and outlet of the side to be cleaned.
  • Remove all excess water from the heat exchanger. This is important so as not to over dilute the solution.
  • Connect flushing adapters to the heat exchanger and the recirculation hoses to the flushing equipment
  • Water test by filling the flushing equipment tank with water and pumping until a closed loop is established.
  • To make sure that no leaks are present in the system, mark the tank’s level, which should be sustained for at least 10 min.
  • Slowly add the proper amount of Trac’s Descaler Concentrate™ into the flushing equipment’s tank. Refer to our Time Chart for the required flushing times.
  • After the circulation, thoroughly drain the solution and fresh water flush the heat exchanger and reconnect.